Wine Glass

This .stl file I found on Thingiverse.  Yesterday I connected the beginning of the new filament to the old one which was almost finished.  I used the trick I learned from  Barnacules Nerdgasm in his youtube Channel.  It is done with a flame and a file....  I did do another item to see if the transition went smooth in the Ultimaker....but the extruder had some problems and could not push the filament further so that the printhead moved but without putting plastic on the item.  I think it is because I file to much and the filament was to thin at this connection.      During the next item I put a little pressure on the filament before it enters the extruder and this made the connection go through the extruder.  Except for the overhang from stem to calyx it went smooth....

It is 9.1 cm high and the print lasted around 3 hours...