Second attempt wall case.

This morning I started the second print. First I changed the position of the two holes in the top of the item to a proper position.  Then in Cura I changed the direction how it should be printed.   This dictates the way the infill is made.   Yesterday the infill was diametrical on the object.  Today it is in line with the object. The estimated printtime is about 11:30 hours..
Here are some stages of the print.  Here is the item after 5:03 hours printtime and 37% done.

Here is the item after 6:53 hours of printing and 52% done.

 And here it is after  8:30 hours of printing and 65% is done.

The infill on the smaller side of the item (in front) is ok. The infill on the larger side of the object (in the back) is not looking that good... It is there but not very well connected.... The support is holding on very good allthough it has a small connection to the item.  

After 9:47 hours of printing and 78% done it looked like this.

And after 11:38 hours the print was ready.   It closed the bottom very good.  A little minus are the parts where the support material is connected to the item.

And here it is on its spot of duty.  The ventilator fits so perfectly in the case that I don't need screws to tighten it.

Some remarks on the design.    The design is very basic.   The electric wire hangs out the bottom.  This could have been done in a different way.