I removed the filament like I would do when I want to insert a new colour. I put it then in again and started a testprint... This ring came out quite well. Nice walls. Only the infill was a bit on the low side but that might be to the design.
The print took 1:02 hours.
I am going to do the "Atomic Nozzle Cleaning". The procedure I found in the forum on Ultimakers website.
Here is the result. From left to right you see the first cleaning to the fifth cleaning. There was a lot of dirt in the printhead.
It is clear that I should do this more often and I mean.. maybe every three months or so...
No comments:
Post a Comment