Blender is fantastic. I modelled a figur and added later an armature to it. This way I could move the different parts of the figur and creating a new posture. This way the figur gets a more realistic gesture. In the lower image you see the split.
And I wanted to try it. So I split the figur again in two parts and started printing the bottompart. After 8:59 hours the print was ready. Again I had worries that the printhead could damage the contruction because it often moved it. But it went ok.... till the end.
Above it the print after 7:46 hours and 85% of the print was done.
The other images show the support material. Later I will print also the upperpart. Cleaning up I will do when both parts are done.
The start of the print for the upperpart went good. But after 4:02 hours of printing and 36% done I notice that the infill is not good. Also the supportmaterial at the side begins to show holes..
After 8:20 hours the print was ready. I am not satisfied with it. As I mentioned half way the printing went bad and it is clearly visuable at the backside of the object..
The object needs to be cleaned.....
Although the print is not that ok I cleaned it and glued it to the bottompart. Here it is next to the early made version of it.
And here in the Bamboo Skewers Cube. So I can change it now and then...
No comments:
Post a Comment