Small test box.

Yesterday I created a small box.  It is just for a test print.  The idea is to make a designer like box that looks like a paperbag.
In Blender I created a box, subdivided it several times  and then used the fractal tool to change the surface.  This worked fine.  My idea was to print it with only a shell but I have to figure out how that is done.

The wall thickness was very low.
The testprint took 1:06 hours to print.  The bottompart is 3 x 3 cm. Height is a little less then 3 cm.

 In this image it is clearly that the wall thickness was to low on a few parts.