The lid for the Padbox and the finished result.

It took 9:16 hours to print the lid that belong to the pad-box. I printed with support material because it is almost a half sphere. It is 4.5 cm height . The wide is the same as the box.
Here is seen how the support material was build.

This was after 88% was done and 8:00 were past..
Here is the complete box.

Between lid and box is seen a small gap. The reason can be the support material. I designed the lid so that it would close perfectly on the box. There are 3 "teeth" on the lid  which goes in the openings on the box.  As a result, there  had to be built support material around the rest of the lid. And this leaves its traces on the underside of the lid. You can see this on the next image.

To make this box really functionable I have to redesign the opening in the bottompart of the box. Something for the next days to do.