I could create quick a middle piece and test printed it right away. It looks good.
The print took 1:11 hours. It is 4.5 cm in height and 3.3 cm wide.
And it fits good in the construction.
There is allthough a problem. The opening on top of the item is to small. After two pieces printed it is always to small. So I redesigned the object and enlarged the top opening by from 3.3mm to 3.46 mm. That should do it.
After 1:02 hours the print was ready. And the hole is just big enough. Again I measured in the blender preview file the distance from that piece to the centerpiece. The skewers have to be maximum 8.5 cm long.
The next day I started printing more middle pieces. After 6 pieces done the cube looks like this.
And here after 10 pieces are ready..... Still 2 to go.
And here finally after a whole day printing all 12 middle pieces are ready. 2 middle pieces to print took each time about 2:04 hours printing. Together they took about 12:30 hours to print. What I still have to do is cleaning them with the dremel.
Measures for the skewers: side skewers 15 cm
middle skewers(middle to centerpiece) 10.7 cm
corner skewers (corners to centerpiece) 8.5 cm
No comments:
Post a Comment