This morning I wanted to start printing the triangle corner elements with a Sky Blue Filament from ColorFabb. But again I had a lot of trouble with this one. 220 didn't work so did 205 degreeds. Also some alterations in speed didn't do it. I gave up on this filament and started a new one. Traffic Red from ColorFabb. Right at the first print it went ok.
Temp: 205, Print speed 45, Infill speed 35, outer and inner shell speed 45.
Here is the print after 1:24 hour and 90% was done.
And after 1:29 hour it was ready.
And here where 4 elements have been printed. It works good. Now I am printing the last red one and then I have to clean the elements of there support residue.
Finally in the afternoon all 4 are ready. The perspective in the next image looks odd but it is due to my position. The object isn't as stabil as it was with the skewers Cube. But the challenge was to make those corner elements with the right angles..
A couple of day later I cleaned the items of their support residue and shortened the bamboo skewers to 10 cm each. It looks quite nice now..
No comments:
Post a Comment