The next four cornerpieces

After 3:26 hours two cornerpieces were ready.

And here is an idea how it will be... They need to be cleaned. I have still to design the 12 side pieces.  The design for the new centerpiece is ready and can be printed.  The estimated time for that piece will be 9 hours....

Immediately after these two I started the print for the last two cornerpieces.  But during the start already something went wrong with the feeder.  No filament was extruded.

I have unlocked the feeder while I preheated the extruder to 210 degreeds.  I pulled the filament out like I would for changing the filament.  It was clear that the feeder had grinded the filament.  I cut the end of the filament to a small tip and  imported it again in the bowder tube.  Reassembled the feeder and started a testprint.  All went well.  So I started the print for the last two cornerpieces again.

And after 3:27 hours they were ready.  And here is the basic Bamboo Skewers Cube...  Now the print for the centerpiece can start...